where g1 to g12 are the optimal fee

where g1 to g12 are the optimal feedback gains. These gain values are given in Table 1. Computer simulation of both the control forces can be obtained using MATLAB [14]. The difference between the control forces u and u1 is that the former is designed with respect to relative displacement and the latter is evaluated with respect to the relative displacement from the reference.

結果 (中文) 1:

g1 到 g12 在哪里最优反馈增益。这些值在表 1 中给出的增益。计算机模拟的两个控制力，可以采用 MATLAB [14]。Difference 之间控制部队你和 u1 是前者这种设计相对位移和后者的评价从引用的相对位移。

結果 (中文) 3:

在G1到G12的最优反馈增益。这些增益值在表1中给出。两者的控制力可以通过Matlab [ 14 ]获得的计算机模拟。二ff分U和U1，前者是针对相对位移和后者的控制力之间是从基准的相对位移方面的评估。