19. Fencing
19.1 The Locator shall build the fences fully enclosing its Plot on the property
lines as set out herein, only except for the entrance and exit as stated in Article 16, the boundary fence built by MJTD, the Ring Main Unit installed by MJTD and the provisions of Article 19.3.1 apply. Before Locator starts construction of Fences, Locator and MJTD shall confirm property line by written evidence. After property line confirmation, Locator shall be able to start construction of the Fences.
19.2 Internal Roadway Fences
19.2.1 The Locator shall erect the fences along Internal Roadways and between the Locator's plot and MJTD common area in accordance with Article 19.1. The fences shall be erected on the established property line of the Locator's plot. During construction of the Fences, MJTD shall assign supervisors to ensure that Fences are erected in accordance with Internal Regulations of MJTD.
19.2.2 The height of fences along Internal Roadways shall be two point four (2.4) meters from ground level.
19.2.3 Fences along Internal Roadways shall be open-type fences made of painted wrought iron bars or galvanized chain-link fencing material framed with galvanized pipes, and other similar types of fences. These roadway fences shall be kept upright by galvanized pipes anchored to the ground with appropriate concrete or solid masonry footing not higher than thirty (30) centimeters from ground level.
19.2.4 No concealing fences such as those constructed from bamboo, wooden or concrete block shall be erected at the front of any property line facing the road. No barbed wire fences shall be erected.
19.3 Fences between Plots
19.3.1 The fences shall be constructed to separate Plots of the Locators.
The center line of Fences between Plots shall be coincidentally constructed by the first Locator entering the Plot on the established property line between Plots. Subsequent Locators entering neighboring Plots shall bear 50% (fifty percent) of construction cost of joint fences. If subsequent Locator does not like the joint Fences constructed by previous Locator, the Locator may construct another Fences adjacent to existing joint fences with previous Locator and does not have to share construction cost for joint fences with previous Locators. Non-concealing
fences are recommended.
19.3.2 Fences between Plots shall be of materials acceptable to MJTD, plaster finish or painted where appropriate, and based on aesthetic standards. Barbed wire shall not be used.
19.3.3 The height of fences between plots shall be two point four (2.4)
meters from ground level.
19.4 Cost for Fence Erection, Maintenance
19.4.1 For Fences erected by MJTD to be used by the Locator, 50% of the fence erection cost shall be borne by the Locator.
19.4.2 For fences with cost-sharing between the first Locator and subsequent Locator, maintenance cost shall be shared equally between the two Locators.