切机定位后就可以连接电源，水源与气源，要求如下：电源变压器容量不低于3

切机定位后就可以连接电源，水源与气源，要求如下：
电源变压器容量不低于300KVA。3相50Hz,380V±10％
电源线用铜线时不得小于3X50mm²+1X10mm²
水源流量不小于20L/分钟
水压力0.2~0.3MPa
气源压力0.6~0.8 MPa
气源流量不小于0.5m³/分钟
气管直径12mm

結果 (英文) 1:

After the positioning of the cutting machine can be connected to the source of power, water and gas requirements are as follows:
power transformer capacity of not less than 300kva. 3-phase 50hz 380v ± 10%
power cord with copper not less than 3x50mm ² 1x10mm ²
water flow is not less than 20l / min
water pressure of 0.2 to 0.3mpa
air supply pressure of 0.6 to 0.8 mpa
flow of gas source 0.5m ³ / min
tracheal diameter 12mm

結果 (英文) 2:

Cutter positioning can connect the power, water and gas supply, requirements are as follows:
power transformer capacity of not less than 300KVA.3 phase 50Hz, shall not be less than 3X50mm ² 1X10mm ²
water flow is not less than 20L/ min
water pressure 0.2~0.3MPa
pressure 0.6~0.8 MPa
gas flow is not less than 0.5m ³ / min
tracheal diameter 12mm
using copper 380V ± 10%
power line

結果 (英文) 3:

Cutting machine positioned after which you can connect the power, water and gas sources, requirements are as follows:
power transformer capacity of not less than 300KVA. 3-phase 50Hz,380V ± 10%
power cable copper wire shall not be less than 3X50mm ² 1X10mm ²

water pressure water flow rate is not less than 20L/minute 0.6~0.8 MPa
0.2~0.3MPa
air supply pressure gas source volume not less than 0.5m ³/min
pipe diameter 12mm