设备和燃气供应应满足的要求。2.2.3压力钢现场焊接，当风速超过5.4

设备和燃气供应应满足的要求。

2.2.3压力钢现场焊接，当风速超过5.4m/s，应该负温风采取措施；施工，采取适当措施保温气体设备；当温度低于15℃，预热和保温措施的联合。

2.2.4场地要有安全防护措施，制定和实施安全技术措施，加强焊工的劳动保护，防止发生烧伤，火灾，爆炸事故和伤害的。
2.2.5必须注意接头位置，同一截面内钢筋接头面积百分率的话，不符合“混凝土结构工程施工及验收规范》等有关规定，应调整焊接接头。

結果 (中文) 3:

The device and gas supply should meet the requirements. Welding of

2.2.3 steel pressure field, when the wind speed is more than 5.4m/s, should take measures to negative temperature wind; construction, take appropriate measures to heat gas equipment; when the temperature is below 15 DEG C, with preheating and heat preservation measures.

2.2.4 site must have the safety protection measures, formulate and implement safety measures, strengthen labor protection of welders, prevent the occurrence of burn, fire, explosion accidents and injuries.
2.2.5 must pay attention to the joint position, in the same section of reinforced joint area percentage, does not comply with the relevant provisions of the "concrete structure engineering construction and acceptance specification", should adjust the welding joint.