Step 3: Assign VLANs to switch port

Step 3: Assign VLANs to switch ports.

Port assignments are listed in the table at the beginning of the activity. Save your configurations after assigning switch ports to the VLANs.

Step 4: Verify the VLANs.

Use the show vlan brief command on all switches to verify that all VLANs are registered in the VLAN table.

Step 5: Assign the trunks to native VLAN 99.

Use the appropriate command to configure ports F0/1 to F0/4 on each switch as trunk ports, and assign these trunk ports to native VLAN 99.

Configure the management interface on all three switches with an address.Verify that the switches are correctly configured by pinging between them.

結果 (中文) 1:

第 3 步︰ 指定 Vlan 的交换机端口。在开始时的活动表中列出的端口分配。将交换机端口分配给 Vlan 后保存您的配置。步骤 4︰ 验证 Vlan。在所有交换机上显示 vlan 简短的命令用于验证所有 Vlan VLAN 表中都注册。步骤 5︰ 将树干分配给本机 VLAN 99。使用适当的命令来将每个交换机上的端口 F0/1 到 F0/4 配置为中继端口，并将这些中继端口分配给本机 VLAN 99。在与地址的所有三个交换机上配置管理界面。验证交换机的正确配置通过 ping 它们之间。

結果 (中文) 3:

步骤3：指定的VLAN交换机端口。在活动开始时，在表中列出的端口分配。保存指定交换机端口VLAN的配置后，您的。步骤4：验证VLAN。使用所有交换机上的VLAN显示简短的命令来验证所有VLAN的VLAN表注册。步骤5：将树干的本地VLAN 99。使用适当的命令来配置端口F0 F0 / 1 / 4在每个交换机中继端口，并将这些主干端口的本地VLAN 99。配置三交换机地址管理界面。确认开关侦测它们之间正确的配置。