erviceability

erviceability

結果 (繁體中文) 1:

可服務性

結果 (繁體中文) 2:

Digital I/O functionality

13.1 FLIR A310 and A320
• The state (high or low voltage) on an input pin is used to start an event in the camera, for instance set a flag in the image stream or trig an alarm activity.
• The state (high or low voltage) on an output pin is controlled by an activity in the camera, for instance by the result of an alarm detection
See the section 16 Technical data, page 27 for details on voltages, etc.
13.2 FLIR A315 and A325 (A320G)
• The state (high or low voltage) on an input pin is used to mark images for use by an application.
• The state (high or low voltage) on an output pin is controlled by an application.
See the section Technical data for details on voltages, etc.

14 Temperature screening

14.1 Applicability
This section applies to the following camera models:
• FLIR A320 Tempscreen (30 Hz).
• FLIR A320 Tempscreen (9 Hz).
14.2 Description of the function
The screening function in allows you to screen a large number of persons for facial temperatures that lie above a set reference temperature.
When an elevated temperature is detected, the camera will trigger a visible and/or audible alarm. Note
• You can change the temperature by 2°C (3.6°F) (described below) using the Screening tab in FLIR IR Monitor (included on the ThermoVision System Tools & Utilities 1.5.1 HF2 (1.5.1.16)). HF2 can be downloaded from http://support.flir.com.
• The camera should run for at least 30 minutes before carrying out measurements.
• The distance to the face should be adapted so that the face covers more than 75% of the image width.
14.3 Procedure
Follow this procedure:
1. Connect the camera to a video monitor.
2. Connect the camera to power.
3. Connect the IN 1 port to +10–30 V DC, using cables and an NO (normally open) electrical switch.
4. Aim the camera at a face (at the inner corner of an eye) that is assumed to have a normal temperature. Close the switch for a period of less than 2 seconds to acquire a temperature sample. Repeat this procedure on at least 10 faces that are assumed to have a normal temperature. You have now set the reference temperature. If you want to reset or restart the reference temperature, close the switch for a period of more than 2 seconds. See the schematic drawing on the next page for set-up details.
5. You can now begin screening. Aim the camera at the faces of people whose facial temperature you want to screen (at the inner corner of the eye). If a person’s facial temperature is more than 2°C (3.6°F) above the set reference temperature, an alarm will be triggered.
14 Temperature screening

結果 (繁體中文) 3:

服务性