本设计是将课程内容与工程实践联系起来。根据任务书所给资料进行挡土墙结构

本设计是将课程内容与工程实践联系起来。根据任务书所给资料进行挡土墙结构类型的选择，并作出说明。参阅资料根据工程经验及规范，初步拟定挡土墙的墙身断面尺寸。进行荷载换算、土压力计算、基底应力及偏心距计算。验算挡土墙墙身强度及稳定性。如不满足要求，进行断面调整，直至满足要求为止。，绘制墙身平面图、纵面图、横断面图，并要求布置泄水孔，排水沟及伸缩缝等结构，提出施工注意事项。计算有关工程数量。

結果 (英文) 1:

The course content is designed to link up with the engineering practice. According to the data of the mission statement of the retaining structure type choices and explanations. See the information based on the engineering experience and norms, tentatively retaining walls to section size. For load conversion, earth pressure calculation, calculation of basal stress and eccentricity. Checking the strength and stability of retaining walls. If not satisfy requirements for a cross-section adjusted until meet the requirement. , Draw walls floor plan, longitudinal maps, cross-sectional diagram and layout requirements scuppers, drains and expansion joints and other structures, proposed construction considerations. Calculate the number of the works.

結果 (英文) 2:

This design is to connect the course content and the engineering practice. According to the task book to data of retaining wall structure type selection, and give explanation. See information according to the engineering experience and norms, initial development section of the wall body size of retaining wall. For equivalent load, the calculation of earth pressure, stress and eccentricity of the basement calculation. Check retaining wall wall body strength and stability. If not meet the requirements of section, adjustment, until the meet the requirements so far. Drawing, wall body plan, profile, cross section, and arrangement of drainage holes, drain and expansion joint structure, puts forward the matters needing attention in the construction. The calculation of Engineering quantity.

結果 (英文) 3:

This design is to link course content and engineering practice. According to the task books for retaining wall structure of the information types to choose and make notes. See information under the engineering experience and norms, preliminary section sizes of retaining walls. Loading conversions, earth pressure, stress and the calculation of the eccentricity of the basement. Checking calculation of retaining walls for strength and stability. Does not meet the requirements of section adjustment, and so on until meet the requirements. , Mapping of wall floor plans, longitudinal, cross section, and is required to put drainage holes, drains and the joints and other structures, proposed construction notes. Count the number of related projects.