1.将粘合面的油质尘垢等污物清洁干净，必要时须打磨粗糙。2.用刮板或毛

1.将粘合面的油质尘垢等污物清洁干净，必要时须打磨粗糙。
2.用刮板或毛刷在粘合面由内向外均匀涂胶，防止欠胶，常温23±2℃，湿度

結果 (英文) 1:

1. clean the adhesive surface of oily grime and dirt and, if necessary, to Polish rough.2. with a scraper or brush on adhesive surface coating evenly from the inside out to prevent defaulting gel at room temperature 23 ± 2 ℃, humidity under <70% about 5-15 minutes hang reset (the layer non-stick hand shall prevail).3. once on the adhesive surface, squeeze from inside to outside (excluding bubble), with a rubber hammer or gavel of percussion compaction, can be achieved using the strength after 1 day, after 5 days up to optimum strength.

結果 (英文) 2:

1. The adhesive surface oil and dirt clean dirt shall roughening if necessary.
2. Use a brush or scraper adhesive surface from the inside out in a uniform coating to prevent gum owed under room temperature 23 ± 2 ℃, humidity <70% dry conditions set for about 5 to 15 minutes (with a little glue tack prevail).
3. once aligned with the adhesive surface, pressing from the inside out (remove air bubbles), with a rubber hammer or mallet percussion compaction, 1 day up to the intensity of use, 5 days to reach optimum strength.

結果 (英文) 3:

1 will the bonding oily dirt and dirt clean, rough when necessary.2 with a scraper or brush on the adhesive surface from the inside out uniform coating, prevent less adhesive, at 23 - 2 DEG C, <70% humidity air for about 5~15 minutes (the layer slightly non stick in hand.).3 alignment adhesive surface, from the inside out extrusion (excluding bubbles), with rubber hammer or wood hammer percussion compaction, 1 days can reach the intensity of use, after 5 days to achieve the best strength.