Refer to Example 7.15 concerning th

Refer to Example 7.15 concerning the variability of the amount of fill at a cannery.Suppose regulatory agencies specify that the standard deviation of the amount of fill should be less than.1 ounce .The quality control supervisor sampled n=10 cans and measured the amount of fill in each.The data are reproduced in Table 8.8.Does this information provide sufficient evidence to indicate that the standard deviation of the fill measurements is less than .1 ounce?

結果 (繁體中文) 1:

參照實施例7.15關於填充物的量的可變性在cannery.Suppose管理機構指定填充物的量的標準偏差應該小於than.1盎司.The質量控制監採樣的N = 10罐和測量的量填充在each.The數據表8.8.Does轉載此信息提供充分的證據表明，填充測量的標準偏差小於0.1盎司？

結果 (繁體中文) 2:

有關罐頭廠灌裝量的可變性，請參閱示例 7.15。假設監管機構規定填充量的標準差應小於.1 盎司。品質控制主管對 n=10 罐進行取樣，並測量每個罐的填充量。資料在表 8.8 中重現。

結果 (繁體中文) 3:

關於罐頭廠灌裝量的可變性，請參攷示例7.15。假設監管機构規定灌裝量的標準差應小於0.1盎司。品質控制首長取樣n=10罐，並量測每個罐的灌裝量。數據見錶8.8。該資訊是否提供足够的證據表明填充量測的標準差小於0.1盎司？