牛油紙用來壓翅面用的，膜的角和邊用大頭針固定。前翅前緣與中軸線垂直或稍

牛油紙用來壓翅面用的，膜的角和邊用大頭針固定。前翅前緣與中軸線垂直或稍呈銳角擺放，一般來說擺放垂直即可，但對鱗翅目尤其是翅面積較大的蝶類，前翅前緣呈銳角才顯得自然，且前後翅都能顯露出來。前後翅翅脈不重疊，後翅前緣通常和前翅後緣相接擺放。蜻蜓目前後翅幾乎平行，雙翅目的後翅退化成平衡棒，都是展翅比較簡單的類群。在這一點上同樣是鱗翅目略麻煩，半翅目同翅亞目某些昆蟲的後翅過於柔軟和寬大，也會比較難展開。大多數昆蟲都是要展兩對翅的，把握好前翅和後翅的連鎖會讓展翅變得容易些。同翅亞目、鱗翅目和膜翅目的連鎖是很容易找到的，用鑷子輕輕向前拉前翅前緣，只要前翅和後翅貼得足夠近，常常能帶動後翅，這時找到前翅前緣需要固定的位置，後翅能自動擺放到自然展開的位置，這樣整姿得到的翅會非常自然美觀。最後是前後翅分開展，先展前翅，壓好固定，再用同樣的方法展後翅。因為翅的前緣是昆蟲翅上最堅固的地方，鑷子輕夾前緣脈調整位置，覆膜用手輕按住，鋪平，取大頭針固定住膜的四角和邊。一些昆蟲的前後翅連鎖則可以用一張膜壓前後翅。

結果 (英文) 1:

Butter paper used for pressing finned surface, and the angle of the film with a pin fixing side. The wing leading edge and perpendicular to the axis at an acute angle or slightly placed generally placed perpendicular to, but especially Lepidoptera butterflies larger wings, wing leading edge at an acute angle it seems natural, and front and rear wings are can be revealed. Front and rear wing veins do not overlap, the wing leading edge and trailing wing edges is generally placed in contact. Dragonfly wings almost parallel to the current, after Diptera wings degenerated into balance sticks, wings are relatively simple groups. At this point a little trouble also Lepidoptera, Hemiptera too soft and lenient Homoptera hind wings of certain insects, will be more difficult to expand. Most insects are to show two pairs of wings, and a good grasp of the forewings and hind wings wings chain will become easier. Homoptera, Lepidoptera and Hymenoptera chain is very easy to find, with tweezers and gently pull the wing leading edge forward, as long as forewings and hind wings stick close enough, can often drive the hind wings, then find the wing leading edge needs to be fixed position, the wings can be automatically placed into the natural deployed position, so that the whole fin posture obtained very natural appearance. Finally, divide the front and rear wings to carry out, the first exhibition wing, pressure is good fixed, and then the same method exhibition wing. Because the leading edge of the wing is the most rugged places insect wings, the leading edge clamp forceps light pulse position adjustment, light hand hold the film, paving, taking corners and edges fixed pins film. Front and rear wing some insects can be a chain of the film before and after pressing wings.

結果 (英文) 2:

Butter paper is used to press the fins, and the corners and edges of the membrane are fixed with a pin. The front wing leading edge and the center axis vertical or slightly sharp angle placement, generally placed vertical can be, but the scales, especially the larger wing area of butterflies, the front wing front edge is sharp angle to appear natural, and front and front wings can be revealed. Front and rear wing veins do not overlap, and the front edge of the rear wing is usually placed in tandend with the front fin. At present, the wings are almost parallel, and the wings of the wings degrade into a balance bar, which are relatively simple groups of wings. At this point is also a slight trouble, half-winged with the wings of some insects are too soft and wide, will be more difficult to expand. Most insects are to show two pairs of wings, grasping the chain of front and rear wings will make it easier to spread wings. The same wing, scaly fin and membrane wing purpose chain is easy to find, with tweezers gently pull forward the front wing leading edge, as long as the front wing and rear wing is attached close enough, often can drive the rear wing, then find the front wing front edge needs to be fixed position, the rear wing can automatically place to the natural expanding position, so that the whole position will be very natural and beautiful. Finally, the front and rear wings are carried out, first spread the front wings, press well fixed, and then use the same method to spread the wings. Because the front edge of the wing is the most strong place on the insect wing, the tweezers lightly clamp the leading edge veins to adjust the position, the coating by hand to hold, tile, take a large needle to secure the four corners and edges of the membrane. Some insects have front and rear fins that can be pressed with a membrane.

結果 (英文) 3:

Butter paper is used to press the wing surface, and the corners and edges of the film are fixed with pins. The front edge of the forewing is perpendicular to the central axis or slightly at an acute angle. Generally speaking, the front edge of the forewing can be placed vertically, but for Lepidoptera, especially for butterflies with large wing area, it is natural that the front edge of the forewing is at an acute angle, and the front and rear wings can be exposed. The veins of the front and back wings are not overlapped, and the leading edge of the back wing is usually placed next to the trailing edge of the front wing. At present, dragonflies' hind wings are almost parallel. The hind wings of Diptera degenerate into balance bars, which are all relatively simple groups with wings spread. At the same time, Lepidoptera is a little troublesome. Some insects of Hemiptera Homoptera, whose hind wings are too soft and wide, will be difficult to expand. Most insects need to develop two pairs of wings. It will be easier to grasp the linkage between the front wing and the back wing. It is easy to find the linkage of Homoptera, Lepidoptera and membranoptera. Use tweezers to gently pull forward the front edge of the front wing, as long as the front and rear wings are close enough, they can often drive the rear wing. At this time, find the fixed position of the front edge of the front wing, and the rear wing can be automatically placed in the position of natural expansion, so that the whole wing will be very natural and beautiful. Finally, the front and back wings are divided into two parts. First, extend the front wing, press and fix it, and then extend the back wing in the same way. Because the leading edge of the wings is the most solid place on the wings of insects, tweezers gently clip the leading edge vein to adjust the position, cover the film and press it gently with hands, smooth it, take a pin to fix the four corners and edges of the film. In some insects, a membrane can be used to press the front and back wings.