收集過多的雨水，減少地面積水的情況。此裝置分為上下兩層，上層為盆栽，下

收集過多的雨水，減少地面積水的情況。此裝置分為上下兩層，上層為盆栽，下層為蓄水箱。下雨時，雨滴落入蓄水盆儲水，在入口設置濾網，過濾水中砂石，利用滑軌將上層盆栽往下降入蓄水箱內，使盆栽內的土壤浸濕，約莫30秒後裝置上升，多餘的水分則重新流入蓄水箱內，每天早晚各循環一次。盆栽內部分為土層與石砂層，利用濾網隔層阻擋內容物流失，下層石砂是再次避免土層流失。當水箱的水到達一定的刻度時，浮標可防止過多的雨水從外部入口進入，盆栽下降時也可防止內部水箱水溢出。

結果 (英文) 1:

Collect excess rainwater, reducing the ground water situation.
This apparatus is divided into upper and lower levels, the upper pot, the lower the water storage tank.
When it rains, rain water falling into the water storage basin, is provided in the inlet filter, filter sand in water, using the upper rail pot
to fall into the water storage tank, the soil in the pot wet, after approximately 30 seconds means rises, the excess water flows back
into the water tank, the cycle once a day, morning and evening. Internal potted into soil and sand stone, using a sieve barrier blocking the
content stream out, the lower sand stone is again avoided topsoil.
When the water reaches a certain scale tank, the float is prevented excess rainwater from the outside entrance of water inside the water tank is prevented from overflow pot drops.

結果 (英文) 2:

Collect too much rainwater to reduce water accumulation on the ground.
The unit is divided into two layers, the upper layer is potted and the lower layer is a water storage tank.
When it rains, raindrops fall into the reservoir, set a filter in the entrance, filter the sandstone in the water, and use the rails to plant the upper pot
Drop into the reservoir, soak the soil in the potted plant, and after about 30 seconds the device rises and the excess water flows again
Into the reservoir, cycle once a day morning and evening. The inside of the potted plant is divided into soil layer and stone sand layer, which is blocked by the filter compartment.
Capacity logistics loss, the lower layer of stone sand is again to avoid soil erosion.
When the water in the water tank reaches a certain scale, the buoy prevents excessive rain from entering from the outside entrance and the internal water tank from escaping when the potted plant falls.

結果 (英文) 3:

Collect too much rainwater and reduce the water on the ground.
The device is divided into two layers, the upper layer is potted plant and the lower layer is water storage tank.
When it rains, the raindrops fall into the water storage basin to store water. A filter screen is set at the inlet to filter the sand and stone in the water, and the upper potting is conducted by using the slide rail
Lower it into the water storage tank to make the soil in the potted plant wet. After about 30 seconds, the device will rise, and the excess water will flow again
It is put into the water storage tank and circulates once in the morning and evening every day. The inside of the potted plant is divided into soil layer and stone sand layer, which is blocked by the filter screen
The lower layer of stone and sand is to avoid soil loss again.
When the water in the water tank reaches a certain scale, the buoy can prevent excessive rainwater from entering from the external inlet, and the water in the internal water tank can also be prevented from overflowing when the potted plant falls.