本節所介紹之檢定方法，為鑑別不正常型態中最主要之一種。此項檢定方法可以

本節所介紹之檢定方法，為鑑別不正常型態中最主要之一種。此項檢定方法可以判斷是否有各種因素不斷地在變化。在作此項檢定時，僅取管制圖之一半來作研討說明，即在中心線與任何一管制界限之間，然後再將此一半管制圖等分為三個區域，各區域之命名如下圖所示。因為管制圖所用之管制界限，為三個標準差（σ）管制界限，故每一區域之寬度，恰為一個標準差。因此對此分法吾人又可稱為「一個標準差區域」「兩個標準差區域」及「三個標準差區域」等等。茲將各項檢定方法，列舉如下，每一方法中，並附圖說明。符合任何下述之一項者，即為不正常之型態。

結果 (英文) 1:

This section describes the test methods that, for the identification of the most important abnormal patterns of one kind. This test method can determine whether there is a variety of factors constantly changing. In making this test, to take only half of FIG controls to make discussion described, i.e., between the center line and any control limit, then this half control diagrams divided into three areas, each area designated as FIG. Fig. Since the control limits used by the control chart, as three standard deviations ([sigma]) the control limits, so that the width of each area, the difference is just a standard. So this points system I can be called "a standard deviation area" "two standard deviations region" and "three standard deviations region" and so on.
The method of the assay is hereby listed below, each of the methods, the drawings and description. Compliance with any of the following of a person, that is not the normal type.

結果 (英文) 2:

The method of verification described in this section is one of the most important to identify abnormal patterns. This verification method can determine whether there are various factors constantly changing. At this time, only half of the control chart is taken for the study, i.e. between the central line and any control boundary, and then the half control chart is divided into three regions, named as shown in the figure below. Since the control boundaries used in the control chart are the three standard deviations (s) control limits, the width of each area is exactly one standard deviation. Therefore, this sub-person can also be referred to as "one standard deviation area" "two standard deviation areas" and "three standard deviation areas" and so on.
The various methods of verification are listed below, in each method, and illustrated with illustrations. Conforms to any of the following, i.e. an abnormal pattern.

結果 (英文) 3:

The verification method described in this section is one of the most important methods to identify abnormal forms. This test method can judge whether there are various factors constantly changing. During this inspection, only one half of the pipe drawing is taken for discussion and explanation, that is, between the center line and any control boundary, and then the half of the control drawing is divided into three areas. The names of each area are shown in the figure below. Because the control limits used in the control chart are three standard deviation (σ) control limits, the width of each area is exactly one standard deviation. Therefore, we can call this method "one standard deviation region", "two standard deviation regions" and "three standard deviation regions" and so on.
The verification methods are listed as follows, in each method, and illustrated with figures. Any of the following is considered abnormal.