1 connect the servo motor to the bo

1 connect the servo motor to the board of the board of the teaching board.
2 the left side of the servo motor control line is connected to the P11 port, and the right side to the servo motor control line is connected to the P10 port. As shown in Figure 3-13
3 the teaching board is placed on the top of the four bracket to align it with the four long screw holes.
4 make sure that the bread plate is close to the driving wheel instead of the tail wheel.
5 with a flat screw connection board and bracket. In this way, the whole baby car robot will be installed with 6 from the bottom of the chassis through the rubber ring to the rest of the servo motor wire and battery wire pull.
7 rolled up and the remaining line between the servo motor and the chassis.

結果 (中文) 1:

1 连接到教学管理委员会董事会的伺服电机。2 左侧的伺服电机控制线连接到 P11 端口和右侧向伺服电机控制线连接到 P10 端口。如图 3-13 所示3 教学板放置在四个支架与四个长的螺丝孔对齐。4.确认，面包板是而不是尾轮驱动轮。5 与扁螺旋连接板和支架。这种方式，整个婴儿车机器人将装有 6 从机箱底部的橡胶圈通过对其余的伺服马达电线和电池线拉。7 卷起和伺服电机和机箱之间的剩余行。

結果 (中文) 3:

1将伺服电机连接到教学板板。
2伺服电机的控制线左侧连接到P11口，和右边的伺服电机的控制线连接到P10口。如图3-13
3教学板放在四个支架上使其与四长螺丝孔所示。
4确保面包板靠近车轮而不在尾轮。5与平板螺钉连接板和支架。以这种方式，整个婴儿车的机器人将安装有6从底盘底部通过橡胶圈，其余的伺服马达电线和电池丝拉。7在伺服马达与底盘之间的滚落。