For eNBs identified by serial numbe

For eNBs identified by serial number, it is imperative that the OAM link port configured in the EMS matches the OAM link port obtained by the eNB during PnP procedures. If eNB obtains Candidate EMSs from DHCP, eNB receives both IP addresses and ports. If eNB obtains Candidate EMSs from DNS, eNB only receives IP addresses, no ports, and so it uses default port 162 in this case.
Two Use Cases are described below: (1) EMS and eNB OAM Link ports match and (2) EMS and eNB
896 OAM Link ports mismatch.

結果 (中文) 1:

为 eNBs 由序列号标识，势在必行的配置在 EMS 的 OAM 链接端口匹配即插即用的过程中所得的 eNB OAM 链接端口。如果 eNB 从 DHCP 获得候选人资格，eNB 接收 IP 地址和端口。如果 eNB 从 DNS 获得候选人资格，eNB 只接收没有端口的 IP 地址，所以它在这种情况下使用默认端口 162。两个用例说明如下: (1) EMS 和 eNB OAM 链接端口匹配和 (2) EMS，eNB896 OAM 链接端口不匹配。

結果 (中文) 3:

通过序列号识别基站，当务之急是OAM链路端口配置在EMS比赛期间，PNP程序由eNB获得OAM链路端口。如果eNB得到候选EMSS从DHCP，eNB接收IP地址和端口。如果eNB得到候选EMSS从DNS，eNB接收IP地址，没有端口，所以它使用默认端口162在这种情况下。两个用例描述如下：（1）EMS和ENB OAM链路端口匹配（2）EMS和ENB896 OAM链路端口不匹配。