一、概述TK系列三相同步电动机是专门为空气压缩机配套的同步电动机，适用

一、概述
TK系列三相同步电动机是专门为空气压缩机配套的同步电动机，适用于海拔不超过1000m， 环境温度低于40℃，少灰尘，无蒸气、酸、碱等腐蚀性气体的室内环境。
该系列高压电动机额定电压为6000V或10000V，允许电压的偏差范围为±5%，电源的额定频率为50Hz，额定功率因数为0.9（超前）。
该同步电动机励磁系统采用静止可控硅励磁装置。该电机允许全压直接起动，当电网容量不允许全压起动时，也可降压起动。
本系列电动机的功率等级，安装尺寸，电气性能均符合国家标准GB755《旋转电机基本技术要求》，国际电工委员会IEC标准。
二、结构简介
TK空气压缩机用大型交流三相同步电动机，机座为钢板焊接结构，带底架；防护等级IP00，冷却方式IC01风扇自冷，也可制成IC37管道通风，安装型式IM7311或不带转轴和座式轴承的IM5710，定额类型S1，定子绕组接线方法Y接，绝缘等级F（按B级考核）。
定子采用0.5毫米厚的低损耗硅钢薄板冲制的扇形片叠压而成，铁芯上有定向通风槽孔，定子绕组采用成型的双迭短矩线圈，绝缘等级为F级；
转子磁极采用钢板冲制而成，与磁极线圈一同装在转子磁轭上，磁极线圈F极绝缘。
三、用途
TK系列大型三相同步电动机主要用于驱动空气压缩机也可用于驱动、水泵、风机等其它机械设备。

結果 (英文) 1:

I. Overview
tk series three-phase synchronous motor is dedicated to supporting synchronous motor air compressor for altitude does not exceed 1000m, ambient temperature is below 40 ℃, less dust, vapors, acids, alkalis and other corrosive gases indoors environment.
The series of high-voltage motors rated voltage 6000v or 10000v, allowable voltage variation range of ± 5%, power rated frequency 50hz, rated power factor of 0.9 (advanced).
The synchronous motor excitation system uses static thyristor excitation device. This motor allows the full voltage direct start, when the grid capacity does not allow full voltage start, they can buck start.
This series of motor power rating, mounting dimensions, electrical properties are in line with national standards gb755 "rotating electrical machines", the International Electrotechnical Commission iec standards.
Second, the structural profile
tk air compressor with a large three-phase AC synchronous motor, base for the steel plate welded structure, with a chassis; protection class ip00, cooling ic01 fan from the cold, can also be made ic37 ventilation pipe, the installation type im7311 or without shaft and pedestal bearings im5710, fixed type s1, y connected stator winding wiring, insulation class f (press b-level assessment).
Stators using 0.5 mm thick low-loss silicon steel sheet punching fan-shaped pieces made of laminated iron core has directed the ventilation slots of the stator windings are double stacked short moments forming coil insulation class f-level;
rotor poles with steel plate punch from the system, together with the pole coil mounted on the rotor yoke, f pole pole coil insulation.
Third, use
tk series is mainly used for large-scale three-phase synchronous motor drive can also be used to drive air compressors, pumps, fans, and other mechanical equipment.

結果 (英文) 2:

One, overview of
TK series three-phase asynchronous motor is a special motor air compressors, applicable to the altitude does not exceed 1000m, the environment temperature is below 40 ℃, less dust, no steam, acid, alkali and other corrosive gases indoor environment.
the series high voltage motor for rated voltage of 6000V or 10000V, allowable error voltage of ± 5%, rated power supply frequency is 50Hz, rated power factor is 0.9 (lead).
the synchronous motor excitation system using static silicon controlled excitation device. The motor to allow direct starting pressure, when the power grid capacity does not allow full voltage starting, can also be reduced voltage starting.
Power ratings, the series motor mounting dimensions, electrical performance conforms to the national standard GB755 "rotary motor basic technical requirements", the International Electrotechnical Commission IEC standard.
large AC three-phase synchronous motor with two, structure of
TK air compressor, a base for the steel plate welded structure, with the chassis; the level of protection IP00, cooling fan IC01 from cold, also can be made of IC37 pipe ventilation, installation type IM7311 or without the shaft and the bearing pedestal IM5710, quota type S1, stator winding wiring method Y, insulation class F (assessment according to B grade).
stator with 05 mm thick low loss silicon steel sheet sector laminations of the pressing, directional ventilation slot iron core, stator winding adopts forming double overlapping short rectangular coil, the insulation class is F;
rotor pole with steel plate punching, and the magnetic pole coils are mounted on a rotor magnetic yoke, pole the F pole coil insulation.
three
TK series, use large three-phase synchronous motor is mainly used for driving the air compressor can also be used for driving, water pump, fan and other machinery and equipment.

結果 (英文) 3:

First, an overview of
TK series air compressor with three-phase synchronous motors are designed for supporting synchronous motor, applies to no more than 1000m above sea level, the ambient temperature is below 40 ° c, less dust, no steam, acids, alkalis and other corrosive gas indoor environment.
The series high voltage motor rated voltage is 6000V, 10000V, allowed deviation of the voltage range is ± 5%, rated frequency power 50Hz, rated power factor 0.9 (Advanced).
The use of static Silicon controlled excitation system for synchronous motor exciter. The motor allows direct start, when the power grid capacity does not allow full pressure when starting, or voltage-reduced starting.
This series electromotor power levels, installation size, electrical performance is in compliance with the national standard GB755 the basic technical requirements for rotating electrical machines, the International Electrotechnical Commission IEC standard.
II, and structure introduction
TK air compressor with large Exchange three-phase synchronization motor, frame for plate welding structure, with base; protection level IP00, cooling way IC01 fan since cold, also can made IC37 pipeline ventilation, installed type type IM7311 or not with hinge and block type bearing of IM5710, fixed type S1, stator winding wiring method y pick, insulated level f (by b level examination).
Stator with a 0.Low loss electrical steel sheet 5 mm thick fan-shaped stack of punched pressure, directional ventilation slots on the iron core, Diego short moments, forming double coil of stator winding, insulation class f;
rotor magnetic pole uses the steel plate punching to become, together with the magnetic pole coil mounted on the rotor yoke, f magnetic pole coil insulation.
Three, use
TK series three-phase synchronous motors are mainly used for large drives can also be used to drive the air compressor, pumps, fans and other mechanical equipment.