Plackets & vents a. Any raw edge in

Plackets & vents

a. Any raw edge in placket or vent construction
b. Vent tack causing pleating, puckering or excessive fullness
c. Excessive twisting or roping of placket or vent
d. Excessive puckering or pleating of placket or vent
e. Placket crooked or not centered by more than ¼”
f. Placket sewn off-grain
g. Placket width varying more than +/- ¼” from top to bottom, or distorted



Pleats
a. Pleat not sewn flat at seam
b. Pleat depth not as specified



Pockets & flaps
a. Pockets set too high or too low
b. Pocket twisted
c. Conspicuously crooked pockets
d. Any amount of raw edge visible underneath flap
e. Top or under flap is tight, twisted, too full, or curled
f. Edge of underside of pocket flap rolled forward (beading) > 1/32”
g. Flap contours turned out (guttered), or top stitched down in a way that adversely affects appearance

結果 (繁體中文) 2:

的門襟和通風口一個。任何毛邊的門襟和發洩建設灣 發洩粘性造成褶皺，褶皺或過度豐滿℃。過度扭曲或門襟或發洩拉攏Ð。過多的褶皺或門襟的打褶或洩如 門襟歪了或不超過¼“為中心F。門襟縫製脫顆粒克 門襟寬度變化超過+/-¼“從上到下，或扭曲褶一個。褶縫不平整的接縫灣 褶深不符合規定口袋和襟翼一個。口袋設置過高或過低灣 掌上扭曲℃。顯著歪的口袋Ð。毛邊可見下方皮瓣的任何量即 頂部或下瓣緊，扭曲，太滿，或捲曲F。袋蓋的側邊緣翻捲著（釘珠）> 1/32“ 克 襟翼輪廓原來（槽形），或頂部的方式不利地影響外觀縫合向下