Comment:CM2 was running not stable

Comment:
CM2 was running not stable from MF point of view in this month.
The connection frame of the lifting table on rewinder was broken and deformed,it makes the extractable rod of the hydraulic cylinder also deformed.
The guiding wheel which were used to support the whole unwinder and splicing unit and also serviced as part of the function of the EPC unit on the unwinder was out of the guiding rail in the evening of Nov 17th.
The supporting bar which were used to support the photocell of the nip roller is hit and deformed.----repair.
The steel chain was splited out of the hook of the hoist during loading the Ceramic Anilox roller on printing unit of CM2.
The water leakage issues on the rotating joint of the cooling roller.----change it.
The motor of the screw on extruder B stopped suddenly.-----shut off and restart.
Bearing fault on some Idle roller.----change it.
PE Resin mixing system fault------PE plastic blocked the sensor. Clean it.
Action:

結果 (中文) 2:

评论：
CM2正在运行但从本月MF点并不稳定。
上复卷升降台的连接帧被打破和变形，它使液压缸也变形的提取杆。
它被用来支撑整个开卷和拼接单元，并作为服务在开卷的EPC单元的功能部分的导轮是从11月17日晚导轨的。
这被用来支持夹持辊的光电管支撑杆命中和变形.----修复。
装载CM2的印刷单元上的陶瓷网纹辊中钢链splited了葫芦的钩。
冷却辊的旋转接头的漏水问题.----改变它。
在挤出机B上的螺杆马达突然停了下来.-----关闭并重新启动。
一些空闲的滚动轴承故障.----改变它。
PE树脂混合系统故障------ PE塑料堵塞传感器。打扫。
行动：

結果 (中文) 3:

评论：
为运行不稳定从本月来看，MF点。
的升降台上复卷机连接架断裂、变形，使液压缸的出杆也变形了。
导向轮，用来支撑整个开卷机和拼接单元和服务作为EPC的单元功能的部分卷了导轨在11月17日的晚上。
支撑杆，用于支持夹辊光电池撞变形。----修复。
钢链被分裂出来的吊钩载荷对平方厘米的陶瓷网纹辊在印刷单元。
冷却辊旋转接头上的漏水问题。----换上它。
对挤出机的螺杆马达B突然停了下来。-----关闭和重新启动。
一些闲置的辊上的轴承故障----改变它。
PE树脂混合系统故障------ PE塑料堵塞传感器。清洁。
行动：