六．注意事项1、本压力机要正确接地，以单独接地为好； 2、机器在运转

六．注意事项
1、本压力机要正确接地，以单独接地为好；
2、机器在运转中不允许校正模具；
3、液压油为N46号抗磨油或N46号低凝液压油，经80~100目丝网过滤后使用，第一次换油时间不超过两个月为宜，以后每六个月换油一次；
4、本机工作200小时后应检查油液清洁度，要求无异味，在白色的滤纸上滴一滴油液，油迹的中心点以内无黑渍，否则应换油；
5、压力机不得过载使用；
6、系统如出现意外泄露，消除故障后应补充足够液压油；
7、经常检查泵站、油箱的清洁、严禁水、灰尘、异物进入油箱；
8、如转换功能，应把系统内空气排净方可工作；
9、在试车及工作中如有异常应立即停机检查；
10、保压10分钟允许降压2.5Mpa.
11.油箱使用容量80L

結果 (英文) 1:

VI. Matters needing attention1, the pressure machine is properly grounded, as a separate ground for good; 2, in the operation of the machine is not allowed to revise molds; 3, its antiwear hydraulic oil N46 oil N46 or low hydraulic oil, wire mesh filters used by the 80~100 accounts, the first oil change for no more than two months, after oil change once every six months;4, the machine after 200 hours of work should check the cleanliness of the oil requires no smell, put a drop of oil on the filter paper in the white, no black spots within the center point of the oil, you should change oil;5, the press shall not be overloaded;6, the system as a result of accidental disclosure, after the Elimination of faults should be enough hydraulic oil;7, always check the pump stations, tank cleaning, no water, dust, foreign matter into the tank;8, such as functionality, should air NET can work within the system;9, trial run and if there are any, should immediately stop check;Packing for 10 minutes to allow buck 10, 2.5Mpa.11. fuel tank capacity 80L

結果 (英文) 3:

Six. Matters needing attention1, the pressure machine properly grounded, with separate grounding as well;2, the machine is not allowed to correct the mold in operation;3, the hydraulic oil for N46 oil or N46 low coagulation antiwear hydraulic oil, 80~100 wire mesh filter used after the first oil change period not exceeding two months is appropriate, after the oil change once every six months;4, the machine after 200 hours of work should check the oil cleanliness requirements, no smell, in the white paper on a drop of oil, oil of the center point within the black stains, otherwise oil;5, the press must not overload;6, the system, such as accidental leakage, to eliminate the fault should be added enough hydraulic oil;7, often check the pump station, oil tank cleaning, no water, dust, foreign matter into the tank;8, such as the conversion function, the system should be the air within the net can work;9, in the test and work if there is abnormal should be immediately shut down inspection;10, 10 minutes to protect the pressure to allow the buck 2.5Mpa.11 fuel tank capacity 80L