按下後可開啟或關閉預設好的夜間保全包含的感應器偵測項目(夜間保全所包含

按下後可開啟或關閉預設好的夜間保全包含的感應器偵測項目(夜間保全所包含的感應器偵測項在 “設定” “用戶設置”  “夜間模式”)，開啟後，圖示會變為綠色，當包含在內的感測器如有其中一項被觸發， 圖示則變為紅色。Note: 本系統最大可支援 8個感測器。 “夜間保全”, “外出保全”與 “居家保全”的設定項可同時包含任一個感測器 (詳細請參考第6章), 當任一感測器被觸發後, 系統會判斷此感測器是啟動狀態還是關閉狀態, 若是處於啟動狀態, 則立即進行告警程序。 “夜間保全”, “外出保全” 或 “居家保全”, 同一時間僅可以存在一種, 系統將以最後被觸碰的選項為主。

結果 (英文) 1:

Can be turned on or off at night preset good preservation project contains sensors to detect press (night preservation detection sensor included in the term "set"  "User Settings"  "nighttime mode"), the open, icon will turn green, when included in the sensor, if one is triggered, the icon turns red.
Note:
The system can support a maximum 8 sensors. "Night preservation", "Out preservation" and "Home Security" setting items may include both any one sensor (Refer to Chapter 6), when any one of the sensor is triggered, this sensing system determines is started or closed, if it is active, then immediately alert program.
"Night preservation", "Out preservation" or "home preservation", the same time may be only the existence of a system will be the last option is touched based.

結果 (英文) 2:

When pressed, the sensor detection item contained in the default good night-time preservation (the sensor detection item contained in night-time preservation is in "Settings" ( "User Settings" , "Night Mode"), when turned on, the icon turns green, and when one of the included sensors is triggered, the icon turns red.
Note:
The system can support up to 8 sensors. "Night Preservation", "Out-of-Home Preservation" and "Home Preservation" settings may contain either sensor at the same time (see Chapter 6 for details), when any sensor is triggered, the system will determine whether the sensor is start-up or off, if it is in the start-up state, immediately alert procedures.
"Night preservation", "out-of-home preservation" or "home preservation", at the same time there can only exist one, the system will be the last touch option.

結果 (英文) 3:

Press to turn on or off the sensor detection items included in the preset night preservation (the sensor detection items included in the night preservation are in "setting"  "user setting"  "night mode"). After turning on, the figure will turn green. If one of the included sensors is triggered, the figure will turn red.
Note:
The system can support up to 8 sensors. The setting items of "night security", "out security" and "home security" can include any sensor at the same time (refer to Chapter 6 for details). When any sensor is triggered, the system will judge whether the sensor is in the start state or the off state. If it is in the start state, the alarm program will be carried out immediately.
"Night security", "out of house security" or "home security" can only exist at the same time, and the system will give priority to the last touched option.