1、BAA測試ok后點膠時推動滑軌，滑軌停止后，畫面偏移2、BAA測試

1、BAA測試ok后點膠時推動滑軌，滑軌停止后，畫面偏移
2、BAA測試ok后輪盤上升時會出現畫面偏移現象
3、UV膠點膠后有浮在黑膠上的現象，造成pcb與hold腳固定不牢，在後續
的模組轉移過程中造成了偏移
4、而在AAA測試時程式并不會卡下此不良,只是做數據收集

結果 (英文) 1:

1, baa test ok dispensing promote the slide, the slide has stopped, the screen offset
roulette after BAA testing ok rise Keystone
3, uv glue dispensing floating in the black gel phenomenon, caused by the PCB and hold the foot fixed is not strong, caused by the offset in the module during the transfer of the follow-up

4 aaa test program and not under the card this bad, just do the data collection

結果 (英文) 2:

1, BAA test OK dispensing pushes the slide, slide stop, picture, BAA offset
2 test OK disc rises will appear screen offset phenomenon of
3, UV glue after the phenomenon of floating in the black glue, causing PCB and hold foot is not firmly fixed, in the subsequent
module transfer process. The offset is
4, and in the AAA test program and not under the card this bad, just do the data collection

結果 (英文) 3:

1, and BAA test OK Hou points rubber Shi promote Rails, Rails stopped Hou, picture offset
2, and BAA test OK Hou roulette rose Shi will appeared picture offset phenomenon
3, and UV rubber points rubber Hou has floating in black rubber Shang of phenomenon, caused PCB and hold feet fixed not prison, in follow-up
of module transfer process in the caused has offset
4, and and in AAA test Shi program and not card Xia this bad, just do data collection