锯片中间的调整套为整数，有100mm,.由于锯片的刀头厚于刀体，各地刀

锯片中间的调整套为整数，有100mm,.由于锯片的刀头厚于刀体，各地刀头与刀体厚度不一样，所以锯片与锯片之间需加调整垫片来调整。调整垫片有0.5mm和1mm两种，可根据具体情况加以调整。锯片安装完成后，尾座推回原位，锁紧螺丝B和C.放下锯片护罩，锁紧螺丝A.

結果 (英文) 1:

Blade middle of the adjustment sleeve is an integer, 100mm blade cutter head is thicker than the cutter body, over the head is not the same as the thickness of the cutter body, between the blade and the blade to be added to adjust shims to adjust. The adjustment shims both 0.5mm and 1mm can be adjusted according to the specific circumstances. Blade installation is complete, the tailstock pushed back into place and tighten the screws b and c. Put down the blade guard, and tighten the screws a.

結果 (英文) 2:

Set adjustment of the saw blade intermediate as integer, 100mm,. The cutter head saw blade thickness on the cutter body, thickness around the cutter head and the cutter body are not the same, so the blade and the blade between the need to add the adjusting shims to adjust.The adjusting shims 0.5mm and 1mm two, which can be adjusted according to specific circumstances.Saw after the installation is complete, the rear seat back, the locking screw B and C. put down the blade shroud, locking screw A.

結果 (英文) 3:

Saw blade adjusting sleeve in the middle of an integer, 100mm. because the saw head thicker than the blade, around the cutter head and cutter body thickness is different, so needed to be adjusted between the saw blade and blade gaskets to adjust. Adjustment gasket and 0.5mm both can be adjusted according to the circumstances. Saw blade when the installation is complete, tailstock back into place, tighten the screws b and c. lower the saw blade guard, lock screws a.