Kevin,
When will you engineer be back to X-Tool with parts to update 076164-65 Checking Fixture so that we can Inspect RM # 20 Angularity?
I need this corrected ASAP.
SET SCREW
PS Why would you design pins into Blind Holes so that we must tear down entire fixture to get them out?
· These pins could have been slip fit pins with set screw to hold in place for the side, No Super Glue or Loctite just simple small tap hole from side of block.
o Loosen the screw and pull out the pin with a magnet,
They are supposed to be making new shorter pins to allow for minus form tolerance with Clearance for Max Material Thickness as well as a new Go / NoGo Check pin.
Need answers and Gauge Updated ASAP.
Thanks,
Jeff